Horn — replacement
Warning: The models covered by this manual are equipped with Supplemental Restraint Systems (SRS), more commonly known as airbags. Always disable the airbag system before working in the vicinity of any airbag system components to avoid the possibility of accidental deployment of the airbag(s), which could cause personal injury (see Section 26).
1. Remove the radiator support trim cover mounting fasteners and remove the trim panel (see Bumper covers — removal and installation).
2. To access the horns on Camry and Lexus models, remove the front bumper cover upper mounting fasteners (see Body), then pull and hold the cover outwards.
Note: On Avalon models, remove the grill section of the bumper cover (see Body).
3. To replace the horn (s), disconnect the electrical connector and remove the bracket bolt (see illustration).
19.3 Horn details (left side shown, right side is the same)
A Horn
B Bumper cover (pulled forward)
C Horn mounting bolt
D Electrical connector
4. Installation is the reverse of removal