Fuel and exhaust systems
Fuel system components — 2AR-FE four-cylinder engine (2010 and later models)
1. Fuel rail
2. Intake manifold
3. Throttle body
4. Fuel injectors
Fuel system components — 2AZ-FE four-cylinder engine (2009 and earlier models)
- Intake manifold
- Throttle body
- Fuel injectors (mounted on the back side of the cylinder head)
Fuel system components — 2GR-FE V6 engine
1. Fuel rail
2. Upper intake manifold
3. Throttle body
4. Fuel injectors (the remaining three are under the upper intake manifold)
Fuel system warnings
Gasoline is extremely flammable and repairing fuel system components can be dangerous. Consider your automotive repair knowledge and experience before attempting repairs which may be better suited for a professional mechanic.
- Don’t smoke or allow open flames or bare light bulbs near the work area
- Don’t work in a garage with a gas-type appliance (water heater, clothes dryer)
- Use fuel-resistant gloves. If any fuel spills on your skin, wash it off immediately with soap and water
- Clean up spills immediately
- Do not store fuel-soaked rags where they could ignite
- Prior to disconnecting any fuel line, you must relieve the fuel pressure (see Air conditioning and heating system — check and maintenance)
- Wear safety glasses
- Have a proper fire extinguisher on hand
Fuel system
The fuel system consists of the fuel tank, electric fuel pump/fuel level sending unit (located in the fuel tank), fuel rail and fuel injectors. The fuel injection system is a multi-port system; multi-port fuel injection uses timed impulses to inject the fuel directly into the intake port of each cylinder. The Powertrain Control Module (PCM) controls the injectors. The PCM monitors various engine parameters and delivers the exact amount of fuel required into the intake ports.
Fuel is circulated from the fuel pump to the fuel rail through fuel lines running along the underside of the vehicle. Various sections of the fuel line are either rigid metal or nylon, or flexible fuel hose. The various sections of the fuel hose are connected either by quick-connect fittings or threaded metal fittings.
Exhaust system
The exhaust system consists of the exhaust manifold (s), catalytic converter(s), muffler(s), tailpipe and all connecting pipes, flanges and clamps. The catalytic converters are an emission control device added to the exhaust system to reduce pollutants.